| Year:
| 92
|
| Make:
| Roper Whitney/Betenbender
|
| Model:
| 8ft x 10Ga
|
| Condition:
| Very Good
|
| Serial #:
| On Request
|
|
| Machine Status: | Still in production
|
| Shipping Info: | We can load
|
| Weight: | 6500
|
| Dimension: L x W x H | |
Machine Location:
|
| City: |
On Request
|
| State: |
North Carolina
|
Country:
|
USA
|
Price:
|
$Sold USD
|
|
| General Description |
- Hydraulic shear
8ft x 10Ga mild steel
solid table top
4 ft squaring arm
36" Hyd. backgage with counter display
General specs from factory-below
Capacity - A-36 Mild Steel (80,000 lb. tensile) 10 Ga.
304 Stainless Steel(At Highest Rake) 10 Ga.
Main Motor (H.P.) .................. 10
Nominal Cutting Length .... 100 inches
Number of Holddowns ............... 15
Knives (Four(4) Cutting ... 100"x1"x3"
Rake of Moving Blade (per ..... 1/4
Back Gauge ....... 36 inches
Strokes Per................. 32
Oil Reservoir (Hydraulic Oil Included). . . . . 42 Gallons
Shipping Weight ............................... 7,000 lbs.
Machine Dimensions:
Overall Height ................. 55 inches
Overall Length ................. 121 inches
Overall Width .................. 74 inches(Including Back-gauge)
Electrical Requirements ................. 230V-28amp/460V-14amp
Recommended Power Line .................. 230V-8ga/460v-12ga
BED - Steel one piece box section, stress relieved; welded to side frame insures positive alignment of bed and housings with beam supports that have removable wear tops which allow (1) convenient change to solid top and (2) plates with pin gauging.
RAM - Steel, stress relieved. Truss rod construction assures blade parallelism without consuming, short span adjustments.
POWER RAKE - allows change of blade rake angle for minimum camber & twist.
HYDRO-MECHANICAL HOLDDOWN - firmly grips material to prevent movement and
tipping. Optional urethane gripping pad protects soft and polished materials from marking.
NON-METALLIC GIBS - provides long service life and allow minimum running clearance for accurate control of blade clearance setting.
FOOTSWITCH CONTROL - is activated from a fully shrouded portable footswitch operating on 120 volts. continued>>>
8' x 125 cont'd -2- Dec. 12, 2007
DRIVE - two hydraulic cylinders pushing or pulling directly on cross-head, no rotating pin action saving on wear.
HYDRAULIC VALVES - in manifold block for a minimum of fitting and piping; "C" frame motor for precision alignment of pump.
STANDARD EQUIPMENT
36" Power Backgauge
Hour Meter
backgage mechanical Readout
48" Squaring Arm With Inlaid Scale
NEMA Electrics
Light Beam/Shadow Line
All Hydraulic Fluid Included
All Steel Construction
American Made Motor Disconnect Switch
Hydraulic Self-Compensating 1” x 3” Knives - (4) Cutting Edges
Holddown Bar Assembly Disconnect Switch
Power Adjust Variable Rake Manual Swing-Up Backgauge
|
| Electrical Description |
|
|
| Comments: |
- Can not move out of operation until Aug 2008
Can be upgraded easily to a 3/16" capacity for approx: $3500.00 bigger cylinders
|
|
