Year:
| 1998
|
Make:
| Betenbender
|
Model:
| 8-10GA
|
Condition:
| Good
|
Serial #:
| On Request
|
|
Machine Status: | Can be powered up
|
Shipping Info: | We can load
|
Weight: | 7000
|
Dimension: L x W x H | |
Machine Location:
|
City: |
On Request
|
State: |
North Carolina
|
Country:
|
USA
|
Price:
| $sold USD
|
|
Buyers Premium:
A 10 % Buyers Premium applies to the final sale price of this item
|
|
|
General Description |
- ** MADE IN THE U.S.A. **
BETENBENDER HYDRAULIC SHEAR QUOTE Model 8-125, 8-10ga 8' x 10 Ga.(mild steel) 1/8" Have Manual Note: Can be easily upgraded to a (3/16" capacity) for additional $1750.00
SPECIFICATIONS: Capacity - A-36 Mild Steel (80,000 lb. tensile) 10Ga. 304 Stainless Steel(At Highest Rake) 10 Ga.
Main Motor (H.P.) ............................ 10 Nominal Cutting Length ........................ 100 inches Number of Holddowns ........................... 15 Knives (Four(4) Cutting Edges) ......... 100"x1"x3" Rake of Moving Blade (per foot) ......... 1/4 Back Gauge Range 36 inches Strokes Per Minute ............................ 32 Oil Reservoir (Hydraulic Oil Included) 42 Gallons Shipping Weight ..................... 7,000 lbs. Machine Dimensions: Overall Height ................. 55 inches Overall Length ................. 121 inches Overall Width .................. 74 inches(Including Back-gauge) Electrical Requirements ........ 230V-28amp Recommended Power Line...... 230V-8ga
BED - Steel one piece box section, stress relieved; welded to side frame insures positive alignment of bed and housings with beam supports that have removable wear tops which allow (1) convenient change to solid top and (2) plates with pin gauging. RAM - Steel, stress relieved. Truss rod construction assures blade parallelism without consuming, short span adjustments. POWER RAKE - allows change of blade rake angle for minimum camber & twist.
HYDRO-MECHANICAL HOLDDOWN - firmly grips material to prevent movement and tipping. Optional urethane gripping pad protects soft and polished materials from marking.
NON-METALLIC GIBS - provides long service life and allow minimum running clearance for accurate control of blade clearance setting.
FOOTSWITCH CONTROL - is activated from a fully shrouded portable footswitch operating on 120 volts.
DRIVE - two hydraulic cylinders pushing or pulling directly on cross-head, no rotating pin action saving on wear. HYDRAULIC VALVES - in manifold block for a minimum of fitting and piping; "C" frame motor for precision alignment of pump.
STANDARD EQUIPMENT 36" Power Backgauge Hour Meter With L.E.D Readout 48" Squaring Arm With Inlaid Scale NEMA Electrics Light Beam/Shadow Line All Hydraulic Fluid Included All Steel Construction American Made Motor Disconnect Switch Hydraulic Self-Compensating 1” x 3” Knives - (4) Cutting Edges Holddown Bar Assembly Disconnect Switch Power Adjust Variable Rake Manual Swing-Up Backgauge neoprene hold down caps
|
Electrical Description |
|
|